How to Specify a Replacement IR Lamp for a Paint-Curing Unit

Start how to specify a replacement ir lamp for a paint-curing unit with a complete requirement and finish with a controlled acceptance test. Keep coating chemistry, panel temperature and booth safety in the same decision. A faster temperature rise helps only within the film and substrate limits.

Collect the original evidence

Use the approved drawing, installed-part record, circuit, controller data, photographs and baseline response. Do not begin from a partial nameplate or an assumed OEM code.

Freeze the specification

Field	Record before ordering	Acceptance evidence
Mechanical	Overall and heated length, diameter, supports and clearances	Drawing and dimensional inspection
Electrical	Voltage, wattage, current, circuit and control method	Rating check and controlled energization
Optical	Emitter type, wavelength family and reflector orientation	Approved description and mapped response
Connection	Terminals, leads, sockets and cooling	Fit, insulation and temperature check

Screen the application limits

Follow the coating technical data for flash-off, temperature, exposure and handling limits.
Match voltage, wattage, current, circuit, heated and overall length, reflector, terminals and mounting.
Include distance, angle, curvature, colour, substrate and nearby heat sinks.
Keep booth ventilation, worker controls and the safe operating sequence active.
Use the coating system’s specified finish or handling checks for release.

Check a product candidate

Henruite documents a ruby halogen short-wave lamp family for automotive paint-booth drying and curing and offers custom replacement. Consult the configured henruite product record once the mechanical, electrical, optical and process requirements are known. A catalogue cannot replace qualification.

Accept and release

Inspect the received part, carry out a controlled energization check, and remap the relevant process response before release.

Intense Infrared Heating Lamps

Search